The Rule Rule-mate® 750 gph Bilge Pump is an all-in-one pump and switch that can run dry for up to 2 hours for convenience. Designed to fit in the lowest part of the bilge for efficient pumping, the pump features a 3/4" discharge outlet for easy setup. The pump will not pump oil and has a snap-off strainer for easy cleaning.
Features and Benefits
Designed to fit in the lowest part of the bilge for easy setup
Can run dry for up to 2 hours for convenience
All-in-one pump and switch; no float switch required
Will not pump oil
Snap-off strainer for easy cleaning
3/4" discharge outlet for easy setup
12 VDC for powerful pumping
Manufacturer warranty - general:
3 years limited
Product height (in.):
Product width (in.):
What's in the Box
Rule Rule-mate® 750 gph Bilge Pump
Rated 5 out of
Great priceIt was fast shipping and the price was about re same to anywhere else
Date published: 2015-09-10
Rated 5 out of
Good productPurchased this product to replace the factory pump in a ranger and it functioned flawlessly.
How can I check the "automatic" function of the pump?
Asked by: Mastercraft surfer
Hello Mastercraft surfer,
At the back of the Rule Rule-mate® 750 gph Bilge Pump under the wires, there is a test feature.
Place your finger on the test area for 5 seconds and the pump should come on.
Answered by: smartinez
Date published: 2017-07-24
I have a rule-mate 750 that needs to be replaced. Want to replace with same. Do the wires connected to the existing pump pull out like a plug from an outlet? Or do I have to cut the wires and reconnect the new pump using some kind of connectors?
Asked by: Ben Spon
Hello Ben Spon,
In regards to the Rule Rule-mate® 750 gph Bilge Pump, you have to cut the wires and reconnect the new pump using connectors.
Answered by: Tpayne2
Date published: 2015-07-17
Is this a two wire or three wire installation?
Asked by: Roadhog
The Rule Rule-mate® 750 gph Bilge Pump has a 3 wire installation. The black pump wire connects to negative (-) side of the battery. Brown pump wire connects to the automatic side of the switch. Brown with white stripe wire connects to the manual side of the switch.