The rugged Attwood® Boat Cover Support System helps prevent water from pooling in the center of your boat cover to protect it and extend its working life. The system's under-the-cover design requires a wooden 2 x 4 (not included) to support your cover and keep it from sagging. For use with boats up to 22'.
Features and Benefits
For boats up to 22' long
Prevents water from pooling in the center of a boat cover
Rugged design for an extended working life
Top plate, bottom plate and tie-down system combine with a wooden 2 x 4 (not included) for proper configuration
Important Product and Safety Information
Proposition 65 warning for California residents: WARNING - This product contains one or more chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
What's in the Box
Attwood® Boat Cover Support System
Rated 2 out of
Not too compatible with pontoonsI bought one 2 weeks ago and put in the middle of my pontoon boat next to helm. Followed directions and right after last rain the tarp was so tight from the pool of water I had to cut the cords holding my boat cover.
Date published: 2017-06-01
Rated 3 out of
Good for snowThis boat cover support system works fairly well for snow. You will need to go and shake the cover every once in a while to get the snow off the low spots but most will roll right off. If it's put on perfectly, which I've only done a few times, rain will run right off. I use this for my 17ft bass boat and most of the time it pools on the bow even though this system has straps that go over the bow.
I quit using this as it takes a little bit to put on and only provides mediocre support. I wouldn't buy it again but others may have more luck.